Useful adjustment settings
For automatically adjusting the PC image.
Press MENU to display the MENU screen, and
then press _ll/l_ to select "Setup".
Press A/Y to select "Auto Sync.", and then
press ENTER.
Press _l/l_ to select "Yes", and then press
ENTER.
" Auto Sync.starts and "Now adjustingtile image."
displays.
Press MENU to exit.
!!
Ordinarily you can easily adjust the picture as
necessary to change image position using Auto Sync.
In some cases, however, manual adjustment is needed
to optimize the image.
Press MENU to display the MENU screen, and
then press 41/_ to select "Setup".
Press A/T to select "Fine Sync.", and then
press ENTER.
Press A/Y to select the specific adjustment
item.
R-Pos. Centers the image by moving it to the left
or right.
V-Pos. Centers the image by moving it up or
down.
Clock Adjust when the image flickers with vertical
stripes.
Phase Adjust when characters have low contrast
or when the image flickers.
Press _/l_ to adjust the item to your desired
position.
Press MENU to exit.
When Auto Sync. is successful, "Completed" displays. If
not, Auto Sync. failed.
,, Auto Sync. may fail even if "Completed" displays.
Auto Sync. may fail if the computer image has low
resolution, has unclear (black) edges, or is moved while
executing Auto Sync.
Be sure to connect the PC to the TV and switch it on
before starting Auto Sync.
,, For resetting all Fine Sync. adjustment items to the factory
preset values, press jk/T to select "Reset", and then
press ENTER.
,' It is not necessary to adjust the "Clock" or "Phase" when a
digital signal is being input, so it cannot be selected.
Q- 32
To Next Page
Loading...
Need help?
General