WatchingTV
Method t
Using OH/_,/V on the remote control unit or on the
TV.
You can change channels in several ways.
r--q
POWER
Method 2
Press FLASHBACK to switch to the previously
tuned channel.
Press FLASHBACK again to switch back to the
currently tuned channel.
TV TV VCR AUDIO
0 0 0
CBL/SAT DVD FUNCTION
o o O
SOURCE LIGHT
GE) OD 5E)
REC
(3D (3E) (3D
(E9 (E9 @
INPUT FLASHBACK
©@
VOL CH
FREEZE MENU
° d::25 °
G®8
-- FAVORITE CH --
®®@®
AQUOS
FLASHBACKwill notwork if no channelhasbeen
changedafterthe TV is turned on.
Method 3
Using remote control buttons 0-9, • (DOT) to select
channels for VHF/UHF/CATV/DIGITAL.
To select a 1 or 2-digit channel number
(e. g., Channel 5):
Press 5_ENT
,, When selecting a 1-digit channel number, it is not
necessary to press 0 before the number.
When you enter 0-9 only, channel sebction will be made if
there is no operation within a few seconds.
To select a 3-digit channel number
(e. g., Channel 115):
Press t_1 _5_ENT
To select a 4-digit channel number
(e. g., Channel 22.1):
Press 2 _2_ • (DOT) _I_ENT
,, When you enter 0-9 only, channel selection will be made if
there is no operation within a few seconds.
,, If you push "0" by itself, nothing will happen.
Complete the above steps within a few seconds.
When you enter 0-9 and - (DOT), channel selection will be
made if there is no operation within a few seconds.
Q- 18
To Next Page
Loading...
