Using external equipment
To watch an HDMI/PC-IN equipment image,
select "INPUT4" or "INPUTS" from "INPUT
SOURCE" menu using iNPUT on the remote
control unit or on the TV.
_I_INPUT4
Press MENU to display the MENU screen, and
then press _11/_-to select "Option".
Press A/Y to select "HDMI Setup", and then
press ENTER.
This setting allows you to skip the HDMI/PC-IN Input
on the Input Selection operation.
Press MENU to display the MENU screen, and
then press _/_ to select "Setup".
Press A/Y to select "Input Skip", and then
press ENTER.
Press A/T to select the Input (INPUT 4,
INPUT 5 or INPUT 6) you wish to skip, and
then press ENTER.
Input 4 (HDMI)
Press 4/_ to select "Yes", and then press
ENTER.
Press MENU to exit.
Press A/Y to select the desired item, and
then press ENTER.
Press _/_ to select the desired setting, and
then press ENTER.
Auto View Enable Set whether or not to use
Disable View Mode based on signal
recognition, including an HDMI
signal.
Audio Digital Select "Digital" for an audio
Select Analog signal via the HDMI terminal.
Select "Analog" for an audio
signal via the R-AUDIO -L
terminal.
Press MENU to exit.
Refer to your external equipment operation manual for the
signal type.
"Audio Select" is only available for INPUT 5.
When connecting an HDMFDVI conversion adapter/cable
to the HDMI terminal, the image may not come in clearly.
Q- 31
To Next Page
Loading...
Need help?
General