Set up “Symbol rate 2” if the cable provider uses several
symbol rates.
*
Menu Description Selectable Item
Scrambled
Stations
Specifies if you
need to add pay-TV
services.
Yes, No
Search
Method
Specifies how you
search channels.
Channel: Extracts
all of information
from a channel
(quick, but needs
corresponding TV
stations).
Frequency:
Checks every
frequency in range
(slow).
Start
frequency
————————— 47.0–858.0 MHz
Network ID
Specifies the network.
Set this to register only
the specified network
ID without registering
any special services.
None, 0–65535
Symbol rate
1*
The symbol rates are
specified by the cable
provider. Input the value
received for CATV.
1000–9000
Symbol rate
2*
The symbol rates are
specified by the cable
provider. Input the value
received for CATV.
1000–9000
QAM
Modulation 1
—————————
16, 32, 64, 128,
256
QAM
Modulation 2
—————————
None, 16, 32, 64,
128, 256
Quick guide
“Analogue Search” setting
01 628.25 02 693.25 03 767.25 04 831.25
The TV searches for, sorts and stores all the
receivable TV stations according to their settings
and the connected antenna.
To abort the initial auto installation in progress, press
6.
After searching for analogue channels, the
screen switches to the “Satellite Search” setting
(Page 14).
NOTE
If you turn off the main power on the Display while
performing “Analogue Search”, the initial auto installation
wizard will not appear. The auto installation function allows
you to execute the installation again from the “Setup” menu
(Page 34).
The initial auto installation wizard will turn off if you leave
the TV unattended for 30 minutes before searching for
channels.
•
•
•
13
To Next Page
Loading...
Need help?
General