38
This chapter describes the peripheral devices that can be used with the machine and explains how to use the finisher
and saddle stitch finisher.
PERIPHERAL DEVICES
Peripheral devices can be installed on the machine to increase its range of functionality.
The peripheral devices are generally optional, however, some models include certain peripheral devices as standard equipment.
(As of November, 2005)
4
PERIPHERAL DEVICES
Product name Product number Description
Original cover MX-VRX1*
1
This holds down the original.
Reversing single pass feeder
(Automatic document feeder)
MX-RPX1*
1
This automatically turns the original over to enable scanning of
both sides.
Stand/1x500 sheet paper drawer
MX-DEX1*
2
Additional tray. A maximum 500 sheets of paper can be loaded
in each tray.
MX-DEX3*
3
Stand/2x500 sheet paper drawer
MX-DEX2*
2
MX-DEX4*
3
Large capacity tray MX-LCX1
Additional tray. A maximum of 3500 sheets of paper can be
loaded in the tray.
To install the tray, a stand/1 x 500 sheet paper drawer or
stand/2 x 500 sheet paper drawer is required.
Exit tray unit
(Right tray)
MX-TRX1*
2
This can be added to the right side of the machine.
MX-TRX2*
3
Finisher MX-FNX1
Output device that enables the use of the staple function and
offset function.
Punch module
MX-PNX1A
Punches holes in copies and other output. Requires a finisher.
MX-PNX1B
MX-PNX1C
MX-PNX1D
Saddle stitch finisher MX-FNX2
Output device that enables use of the staple function, offset
function and pamphlet copy function.
To install the saddle stitch finisher, a stand/1 x 500 sheet paper
drawer or stand/2 x 500 sheet paper drawer is required.
Paper pass unit MX-RBX1 Required when a saddle stitch finisher is installed.
To Next Page
Loading...
Need help?
General
