7-5
SYSTEM SETTINGS►SETTING MODE LIST
SETTING MODE LIST
The following is a list of setting mode items, factory default settings and restrictions for each item.
Status
U: General user; A: System administrator/Administrator
* Some settings can only be configured by the administrator.
Address Book
U: General user; A: System administrator/Administrator
*1 This setting is configured in setting mode on the web page.
*2 Set the Category Setting in System Settings→Image Send Settings→Common Settings→Category Setting of the machine's
setting mode.
SETTING MODE LIST
• Depending on the machine specifications and peripheral devices installed, it may not be possible to use some settings.
• Some setting items can only be configured on the Web page.
Setup Items Factory default setting U A
■ Status (page 7-49)
● Machine Identification (page 7-49) – Yes
*
Yes
● Total Count (page 7-50) – Yes Yes
● Device Status (page 7-50) – Yes Yes
● Network Status (page 7-51) – Yes Yes
● Firmware Version (page 7-52) – No Yes
● Power Reset (page 7-52) – No Yes
● Data List (page 7-52) – Yes Yes
List for User – Yes Yes
List for Administrator – No Yes
Setup Items Factory default setting U A
■ Address Book (page 7-54)
● Address Book (page 7-54)*
1
– Yes Yes
● Category Setting (page 7-56)*
2
– Yes Yes
To Next Page
Loading...
Need help?
General
