Sharp MX-M200D

23
SETUP IN A MACINTOSH
ENVIRONMENT
This chapter explains how to install the PPD file to enable printing from a Macintosh and how to configure the printer
driver settings.
☞ MAC OS X: this page
(v10.2.8, v10.3.9, v10.4.11, v10.5 - 10.5.6)
☞ MAC OS 9.0 - 9.2.2: page 27
MAC OS X
1
Insert the "Software CD-ROM" into
your computer's CD-ROM drive.
Insert the "Software CD-ROM" that shows "Disc
2" on the front of the CD-ROM.
2
Double-click the [CD-ROM] icon ( )
on the desktop.
3
Double-click the [MacOSX] folder.
Before installing the software, be sure to read
"ReadMe First". "ReadMe First" is in the [English]
folder in the [Readme] folder.
4
Double-click the folder corresponding
to the versions of the operating
system.
5
Double-click the [MX-B06] icon ( ).
6
Click the [Continue] button.
7
The License Agreement window will
appear. Make sure that you
understand the contents of the license
agreement and then click the
[Continue] button.
A message will appear asking you if you agree to
the terms of the license. Click the [Agree] button.
• The PS3 expansion kit is required to use the machine as a printer in a Macintosh environment. In addition, the
machine must be connected to a network.
• The scanner driver and PC-Fax driver cannot be used in a Macintosh environment.
The explanations of screens and procedures are primarily for Mac OS X v10.4. The screens may vary in other
versions of the operating system.
Note
v10.3.9
v10.5 -
10.5.6
v10.4.11
v10.2.8
If the "Authenticate" window appears in Mac
OS X v10.2.8, enter the password and click
the [OK] button.
If the license appears in the different
language, change the language in the
language menu.
Note
Note