MX-M182 SIMULATIONS 7-20
26 03 Auditor setting
Used to set the auditor.
* When the coin vendor mode is selected:
1. Sort auto select is OFF.
2. For Japan, the duplex copy use inhibition setting is ON (inhibited).
3. When the auditor mode exclusive-setting is ON (manual paper feed inhibited) and the standard tray is set
to the manual feed tray, the standard tray setting is set to the main tray.
Default:
0
04 Copier duplex setting
Used to set YES/NO of duplex setting.
This must be set to ON when the duplex unit is installed. If this setting is set to OFF on the duplex machine,
the duplex motor does not rotate and paper is not discharged normally, resulting in a paper jam.
Default:
0: MX-M182
1: MX-M182D
MX-M202D
MX-M232D
05 Count mode setting
Used to set the count-up number of the total counter, the developer counter, and the maintenance counter
individually when a special paper (A3/WLT/8K) is passed.
When this simulation is executed, the current set value is displayed.
[1]-[3]:
Enter a value with numeric keys, and press [OK] key or [START] key to save the current adjustment value to
the EEPROM. The machine returns to the sub code input window.
Default:
0
Main
code
Sub
code
Contents Remark
Sim26-3 AUDITOR SET
1:AUDITOR
0=P10 1=VENDOR
2=OTHER
[ 0-2]
Code: Mode
0 : Built-in auditor mode
1 : Coin vendor
2 : Other
0
0
Sim26-4 DUPLEX SET
1:DUPLEX
0=OFF 1=ON
[ 0-1]
Code: Duplex setting
0 : OFF
1 : ON
0
0
Sim26-5 COUNT MODE
1:COUNT MODE
[ 0-3]
1
1
Setting Total/Developer Maintenance
0+2+2
1+1+2
2+2+1
3+1+1
To Next Page
Loading...
Need help?
General
Weight and Dimensions
