5-109
SCANNER/INTERNET FAX
Contents
CHECKING THE INTERNET FAX ACTIVITY
LOG (Image Sending Activity Report)
IMAGE SENDING ACTIVITY REPORT
You can have the machine print a log of recent image sending activity (date, name of other party, time required, result,
etc.). The Image Sending Activity Report contains useful information such as the types of errors that occurred.
The most recent 200 transactions are included in the report.
You can have the machine print the Image Sending Activity Report each time the number of transactions reaches 201,
or at a specified time (once a day only).
INFORMATION APPEARING IN THE RESULT COLUMN
Error types and other information are printed in the result column of transaction and activity reports. When a transaction
report or activity report is printed, check the result of the transaction in the result column and take action as needed.
Examples of messages that are printed in the result column
The contents of the Image Sending Activity Report are erased when the report is printed, and thus it cannot be reprinted.
System Settings (Administrator): Activity Report Print Select Setting
This is used to set the conditions for printing activity reports. The factory default setting is not to print.
The Image Sending Activity Report can be set to print each time the number of transactions reaches 201, or at a specified
time (once a day only).
Message Explanation
OK The transaction was completed normally.
OK REPORT A receive report was requested for a transmission, the transmission was completed normally, and
the receive report was received from the destination.
CANCEL A transmission was stopped while in progress, or a reserved transmission job was canceled.
MEM. FULL The memory became full during reception.
REJECTED An Internet fax was sent from a party that is blocked.
NG REPORT A receive report was requested for a transmission, however, the transmission did not take place
correctly and a transmission failed report was received.
NO REPORT A receive report was requested for a transmission, however, a report was not received within the
timeout time.
NG LIMIT Transmission was not possible because the file size exceeded the machine's file size limit setting.
RECEIVED An e-mail was received, however, the attached file was not a TIFF-F file or there was no attached
file, and thus printing was not possible.
FAIL xx (xxxx) The transaction failed due to a communication error.
First 2 digits of communication error number: Error code from 00 to 99.
Last 4 digits of communication error number: Code for use by service technicians.
To Next Page
Loading...
Need help?
General
