Sharp MX-M503N User Manual

8-7
TROUBLESHOOTING
Contents
Follow the steps below to remove a staple jam.
☞ FINISHER
☞ FINISHER (LARGE STACKER) (page 8-9)
☞ SADDLE STITCH FINISHER (page 8-11)
FINISHER
REMOVING STAPLE JAMS
1
Open the cover.
2
While pressing the lever over to the left,
slide the finisher to the left until it stops.
Gently slide the finisher until it stops.
3
Lower the staple case release lever and
remove the staple case.
Pull the staple case out to the right.
4
Raise the lever at the front end of the
staple case and remove the jammed
staple.
Remove the leading staple if it is bent. If bent staples remain, a
staple jam will occur again.
Take care that a bent staple does not hurt you.

Sharp MX-M503N Specifications

General

Print Technology	Laser
Print Speed	50 ppm
Maximum Print Resolution	1200 x 1200 dpi
Scan Type	Color Scanner
Standard Paper Capacity	1, 100 sheets
Maximum Paper Capacity	5, 600 sheets
Duplex Printing	Yes
Network Connectivity	Ethernet
Functions	Print, Copy, Scan, Fax
Original Size	A3
Warm-up Time	20 seconds
Copy Speed	50 cpm
Scan Resolution	600 x 600 dpi
Maximum Paper Size	A3
First Copy Time	3.9 seconds