Sharp PG-D4010X Setup Manual

-21
When Connecting Using
Telnet
1
Click “Start” from the Windows
®
desktop and select “Run”.
2
Enter “telnet 192.168.150.2” in the
text box that opens up. (If the IP
address of the projector is
192.168.150.2.)
3
Click the “OK” button.
4
“User Name:” is displayed. Input
the user name and press the
“Enter” key.
If a user name has not yet been set, just
press the “Enter” key.
5
“Password:” is displayed. Input
the password and press the
“Enter” key.
If a password has not yet been set, just press
the “Enter” key.
6
Input “setup” and press the
“Enter” key.
SETUP MENU will be displayed.
•
•
•
1
2
3
4
5
6
Setting up the Projector Using RS-232C or Telnet
▼SETUP MENU
-----------------------------SETUP MENU----------------------------
[1]IP Address [2]Subnet Mask [3]Default Gateway
[4]User Name [5]Password
[6]RS-232C Baud Rate [7]Projector Name [8]DHCP Client
[A]Advanced Setup [D]Disconnect All
[V]View All Setting [S]Save & Quit [Q]Quit Unchanged
setup>
If the IP address has been changed, be sure to
enter the new IP address in step 2.
User name and password are not set in the
factory default settings.
If the user name or password is entered
incorrectly three times in steps 4 or 5, SETUP
MENU will be quit.
•
•
•
Note

Sharp PG-D4010X Specifications

General

Brand	Sharp
Model	PG-D4010X
Category	Projector
Language	English