To Next Page

To Previous Page

-24

Setting up the Projector Using RS-232C or Telnet

Save Settings and Quit

([S]Save & Quit)

Save set values and quit menu.

▼SETUP MENU

----------------------------SETUP MENU---------------------------

[1]IP Address [2]Subnet Mask [3]Default Gateway

[4]User Name [5]Password

[6]RS-232C Baud Rate [7]Projector Name [8]DHCP Client

[A]Advanced Setup [D]Disconnect All

[V]View All Setting [S]Save & Quit [Q]Quit Unchanged

setup>s

All Connection will be disconnect.

Continue(y/n)? y

Apply New setting...Done.

1 Enter “s” and press the “Enter” key.

2 Enter “y” and press the “Enter” key.

Quit without Saving Set-

tings

([Q]Quit Unchanged)

Quit menu without saving setting values.

▼SETUP MENU

----------------------------SETUP MENU---------------------------

[1]IP Address [2]Subnet Mask [3]Default Gateway

[4]User Name [5]Password

[6]RS-232C Baud Rate [7]Projector Name [8]DHCP Client

[A]Advanced Setup [D]Disconnect All

[V]View All Setting [S]Save & Quit [Q]Quit Unchanged

setup>q

Quit Without Saving(y/n)? y

Setting Unchanged.

1 Enter “q” and press the “Enter” key.

2 Enter “y” and press the “Enter” key.

Sharp PG-D4010X Setup Manual

Other manuals for Sharp PG-D4010X