Sharp PG-D4010X Setup Manual

-25
Setting up the Projector Using RS-232C or Telnet
IP Address Setting
([1]IP Address)
Setting of IP address.
setup>1
IP Address :192.168.150.2
Please Enter :192.168.150.3
(change)
—> 192.168.150.3
1
2
*
1 Enter “1” and press the “Enter” key.
2 Enter numerical value to be set and press
the “Enter” key.
Display IP address after change (*).
Subnet Mask Setting
([2]Subnet Mask)
Setting subnet mask.
setup>2
Subnet Mask :255.255.255.0
Please Enter :255.0.0.0
(change)
—> 255.0.0.0
1
2
*
1 Enter “2” and press the “Enter” key.
2 Enter numerical value to be set and press
the “Enter” key.
Display subnet mask after change (*).
The setting procedure for each item will be explained. For the basic procedure, please
refer to “Set Items” on page 23.
Default Gateway Setting
([3]Default Gateway)
Setting default gateway.
setup>3
note: “0.0.0.0” means “Using no default gateway.”
Gateway Address :0.0.0.0
Please Enter :192.168.150.1
(change) —> 192.168.150.1
1
2
*
1 Enter “3” and press the “Enter” key.
2 Enter numerical value to be set and press
the “Enter” key.
Display gateway address after change (*).
If the values for IP Address, Subnet Mask or
Gateway of the projector have been changed
via Telnet, the computer cannot be connected
to the projector depending on the computer's
network settings.
•
Note
User Name Setting
([4]User Name)
Carrying out security protection using user
name.
setup>4
User Name :
Please Enter : XX-XXXX
(change) —> XX-XXXX
1
2
*
1 Enter “4” and press the “Enter” key.
2 Enter user name and press the “Enter” key.
Display set user name (*).
User name can be up to 8 characters.
You can input the characters below:
a-z, A-Z, 0-9, -, _
In the default state, user name is not set.
•
•
•
Note

Sharp PG-D4010X Specifications

General

Brand	Sharp
Model	PG-D4010X
Category	Projector
Language	English