-9
Setting up the Projector Network Environment
This section describes the basic procedure for using the projector via the network.
If the network is already constructed, the projector's network settings may need to be changed. Please
consult your network administrator for assistance with these settings.
You can make network settings both on the projector and on the computer. The following procedure is
for making settings on the computer.
Network settings on the computer
Connect a LAN cable (Category 5, cross-over type) between the computer and projector.
LAN cable
(commercially available)
1. Connecting the projector to a computer
Page 10
Adjust the IP settings of the computer to enable one-to-one communications with the projector.
Temporarily change
the computer's IP
address.
2. Setting an IP address for the computer
Pages 11, 12
Adjust the projector network settings to conform to your network.
Use Internet Explorer
(version 5.0 or later)
to make various
projector settings.
3. Setting up a network connection for the projector
Page 13
Microsoft
®
, Windows
®
and Windows Vista
®
are registered trademarks of Microsoft Corporation in the
United States and/or other countries.
PJLink is a registered trademark or an application trademark in Japan, the United States and/or other
countries/regions.
All other company or product names are trademarks or registered trademarks of their respective
companies.
•
•
•
To Next Page
Loading...
Need help?
General
