Sharp VL-PD3U

VL-PD3lb
4. DISASSEMBLY OFTHE SET
Note:
Before removing
the cabinet, turn
off the power supply,
and ascertain that the battery have been removed.
Remove the screws ((D)XiPSF17PO3000)(4pcs.) of the bottom
Up the section of V/F,
and remove the screw
cover and them.
((D)XiPSF17PO3000)(1 PC.).
m
Remove the screws ((F)XiPSN17P04000)(3pcs.), ((B)LX
HZ0050TAFN)(lpc.) of the front cover and the DV terminal’!
screw ((R)XiPSN16PO5000)(1 PC.).
3
.
Remove the claw
. Open the LCD panel, remove the screws ((B)LX-HZ0050TAFN)
(2pcs.), the claws what is connected the cabinet A and remove the
front cover.
Be careful so that not damage the lead wires of microphone when
it removes the front cover.
4.
(G)
I#+?
x
Microphone connector
. Slide the section of V/F, and remove the plate of topside, the
screws ((G)XiPSN17P03000)(2pcs.), and remove the top cover
what is slided toward V/F slide.
5
.
is&
V/F
section
.
Remove the screws ((D)XiPSF17P03000)(2pcs.) and ((C)
XiPSF1704000)(1 PC.).
.
Remove
the screw ((G)XiPSNI 7PO3000)(1 PC.) and battery cover,
6
.
(D)
.
Remove the screw ((D)XiPSF17P03000)(1 PC.) of topside
ant
open the cassette compartment door, remove the screw!
((D)XiPSF17PO3000)(3pcs.) of both sides
and center screws.
Remove the Remote control receiver unit connector, the Zoon
FPC, the EJECT switch connector, the H/A connector, and the
cabinet A.
-@ ((3
.
Remove the screw ((D)XiPSF17PO3000)(1 PC.) topside of cabinei
B and the screws ((H)XiPSN17P02000)(1 PC.) of side surface ant
((G) XiPSN17PO3000)(1 PC.) of rear surface.
(Note.) In case of disassemble or assemble the section of V/F, dc
the work with great care that there are never taint or intermi:
of dust.
4-l