Sharp XE-A137

9
3 Installing a Paper Roll
The register can print receipts. For the printer, you must install the paper roll provided with the register.
NOTE
 Installthepaperrollintheprinter.Becarefulthentosettherollandcutthepaperendcorrectly.
To the printer
Incorrect
To the printer
Correct
Correct Incorrect
(How to set the paper roll) (How to cut the paper end)
1. Remove the printer cover.
2. Lift up the print roller arm.
3. Set the paper correctly in the paper roll cradle as per the diagram.
NOTE
 Beforeplacinganewpaperrollinthepaperrollcradle,cutoff
thepasted(taped)partofthepaperandconfirmthatthecutend
ofthepaperisstraight.
4. Feed the end of the paper along with the paper positioning guides as
per the diagram.
5. While holding down the paper, slowly close the print roller arm, and
push down the arm until you hear a click locking the arm.
NOTE
 Iftheprintrollerarmisnotsecurelylocked,printingisnotdone
right.Ifthisproblemoccurs,openthearm,andclosethearm
asinstructedabove.
6. Cut off the excess paper and replace the printer cover.
7. Press the
F
key to make sure the paper end comes out of the
printer cover and clean paper appears.
NOTE
 Ifthepaperenddoesnotcomeout,opentheprintercover,
andpassthepaperendbetweenthepapercutterandthe
paperguideoftheprintercover,andreplacetheprinter
cover.
Paper positioning guides
Print roller arm