Sharp XE-A137 - Operator Maintenance; Handling Power Failures; Handling Printer Errors

74
SD CARD FUNCTION
The register’s data can be saved to the SD memory card, and the programming data can be loaded from the SD
memory card.
To use the SD card function, turn the mode switch to the Z/PGM position and perform the corresponding
operations.
■
Inserting and removing an SD memory card
The SD card slot is located on the right side of your register.
Inserting an SD memory card
Insert an SD memory card into the SD card slot with the printed SD logo facing
upwards. Push the card in steady with a finger until it clicks and release it slowly.
Removing the SD memory card
Push in the card gently with a finger and release it. The card will come out.
NOTE
 •ThismodelsupportsSDcardsonly.UseofanyothertypesofSDcardssuchasminiSD,microSD,
etc.withanadapterisnotsupported.
 •WheninsertingorremovingtheSDmemorycard,besuretoreleaseitslowly.Otherwise,thecardmay
popoutandinjureyourfinger.
 •NevertouchorremovetheSDmemorycardwhileitisaccessed,otherwisethedatastoredinitmay
bedamaged.
 •FormattingtheSDmemorycarderasesallthedatainit.
Caution: Never turn the power off, while the SD memory card is accessed.
■
SD card formatting
When the SD card is not formatted yet, take the formatting operation.
s A@s
140
The master folder “SHARP/ECRXXX14” is created for the data file.