Sharp XE-A137 - SD Card Functionality; SD Card Formatting

72
The details of the register system modification are as shown below:
Items
A=1
(EURO status 1)
A=2
(EURO status 2)
A=3
(EURO status 3)
General Z1 report Issue Issue Issue
General Z2 report Issue Issue Issue
GT memories
(GT1, GT2 and GT3)
- Clear Clear*1
Conversion of preset prices of Dept./
PLU
- Yes Yes*1
Exchange amount printing for total and
change
Yes Yes No
Exchange calculation method Division Multiplication Multiplication
Domestic currency symbol - [EURO] [EURO]
Domestic currency decimal point
position
- 2 2
Exchange currency symbol [EURO] Previous domestic
currency symbol
-*2
Exchange currency decimal point
position
2 Previous domestic currency
decimal point position
-
Smallest coin (for rounding system) - Normal Normal*1
Rounding up/down of the unit digits of
amount
- 00 00*1
Limit of the least significant digit in
entering amount of item
- Arbitrary Arbitrary*1
Limit of the least significant digit in
entering amount of payment
- Arbitrary Arbitrary*1
Memory of difference due to rounding - No No*1
Rounding of foreign currency for
V
Round off
(4 down/5 up)
Round off Round off
• The item marked with “-” remains the same as the previous data.
*1: When you perform from EURO status 2, previous data remains unchanged.
*2: When you perform from EURO status 1 or 2, “space” is set.
IMPORTANT
• Conversion of the preset unit prices of departments and PLUs
Note that the conversion rate of the preset rate of the
V
key is applied for the conversion, and the method is
set to “division”. When the conversion is performed, the message “PRICE CONVERTED” will be printed on the
#800 report.
• After the execution of the procedure with “A=1”, treat EURO as foreign currency using the exchange key (
V
)
with the preset rate entry. Set the EURO conversion rate as the currency exchange rate for the exchange key.
• After the execution of the procedure with “A=2”, treat EURO as domestic currency, and national currency as
foreign currency using the exchange key (
V
) with the preset rate entry. Set the EURO conversion rate as the
currency exchange rate for the exchange key.
NOTE
 Youcanmanuallymakethesesettings.Forprogrammingdetails,pleaserefertoprogrammingsection.