18
(3) PRICE
Input a unit price in the textbox, which can range from 0 to 999999.99. The default value is zero.
(4) PROGRAM
• Dept. No.
Input the code of the department where the PLU/UPC data is supposed to be classified. The code can range
from 1 to 99. The default value is 1.
• Amount Entry Type
You can select a registration method by checking “OPEN”* and/or “PRESET.”* The default setting is PRESET.
When you check both “OPEN” and “PRESET,” it is set as “OPEN &PRESET.” When you check neither “OPEN”
or “PRESET,” it is set as “INHIBIT.”* This item is active only when you have selected a PLU code.
• Commission No.*
Input a commission number from 0 to 2 in the textbox. The default value is zero.
*Note
For details of register settings refer to the Instruction Manual of XE-A407 and XE-A43S.
(5) PLU/UPC CODE
The selected PLU/UPC code is displayed.
You can see another PLU/UPC data by the following procedure.
1. Click inside of the PLU/UPC CODE textbox.
The PLU/UPC code input dialog box appears.
2. Input a PLU/UPC code in the textbox.
3. Click [OK].
Data with the selected code are shown on the PLU/UPC screen.
You can also change the PLU/UPC code selection with the [<] button
or [>] button.
(6) Get from SD
Click this button to read the PLU/UPC data from an SD memory card.
(7) Send to SD
Click this button to write the PLU/UPC data to an SD memory card.
● To create PLU/UPC data
You can create new PLU/UPC data with the following procedure.
1. Click [Record], and then [New].
1
2
3
1
To Next Page
Loading...
