Sharp XG-PH70X

XG-PH70X/XG-PH70X-N (1st. Edition)
2 – 12
[14] Removing the Power Unit and Audio Unit
1. Remove the four screws from the power unit.
2. Detach the power air guide from the power channel upper.
3. Remove the four screws from the power channel down and then disconnect the two power connector PR.
4. Remove the four screws from the power unit and then take out the power unit.
5. Remove the four screws from the holders and then disconnect the signal connectors SG.
6. Remove the four screws from the audio unit and then take out the audio unit.
Power Unit
14-1
14-2
14-3
14-4
14-5
14-6
Power Channel upper
Audio Unit
Power Air Guide
Holder
Holder
Ballast Unit
Power Unit
Power Unit Insulator
Power Channel Down
SG
Chassis