Sharp XG-PH70X

XG-PH70X/XG-PH70X-N (1st. Edition)
3 – 5
[4] SERVICE MODE
1. How to enter Service Mode
Select the group “Option2” by user menu and then select “service Mode”.
Enter the password “9303”
2. How to adjust in service mode
– Select the group to adjust with the DOWN key or the UP key,
and enter the adjustment item with the ENTER key on the remote control or key pad.
– Select the adjustment item with the DOWN key or the UP key.
– Use the LEFT key or the RIGHT key for adjustment.
– To return from the adjustment item to the adjustment group, use the UNDO key or the MENU key.
NOTE: – In service mode, user adjustment value will be changed to default value (Picture/CMS).
When you exit from service mode, adjustment value will change to user adjustment value.
– In service mode, the following functions will be canceled.
AV mute / sound mute / freeze / enlarge / PinP
* "standby" button on a remote controller and a operation pad is invalid in the service mode.
If you would like to turn off the power, please exit from service mode.
3. Adjustment of white balance
• Adjustment of RGB PC 1. Feed a RGB PC signal to input1
white balance 2. Select the group "DLP"
PH70X will change to input1/RGB mode automatically
group Subject initial value effective range adjustment source/mode
DLP R1-BLK 0 ±20 brightness of red INPUT1 / RGB
R1-GAIN 0 ±20 contrast of red INPUT1 / RGB
G1-BLK 0 ±20 brightness of green INPUT1 / RGB
G1-GAIN 0 ±20 contrast of green INPUT1 / RGB
B1-BLK 0 ±20 brightness of blue INPUT1 / RGB
B1-GAIN 0 ±20 contrast of blue INPUT1 / RGB
• Adjustment of video 1. Feed a video signal
white balance 2. Select the group "DLPV"
PH70X will change to input4 mode automatically
group Subject initial value effective range adjustment source/mode
DLPV V-R1-BLK 0 ±20 brightness of red INPUT4 / video
V-R1-GAIN 0 ±20 contrast of red INPUT4 / video
V-G1-BLK 0 ±20 brightness of green INPUT4 / video
V-G1-GAIN 0 ±20 contrast of green INPUT4 / video
V-B1-BLK 0 ±20 brightness of blue INPUT4 / video
V-B1-GAIN 0 ±20 contrast of blue INPUT4 / video
• Adjustment of DTV 1. Feed a component signal to input1
white balance 2. Select the group "DLPV"
PH70X will change to input1/component mode automatically
group Subject initial value effective range adjustment source/mode
DLPV C-R1-GAIN 0 ±20 contrast of red INPUT1 / component
C-G1-GAIN 0 ±20 contrast of green INPUT1 / component
C-B1-GAIN 0 ±20 contrast of blue INPUT1 / component
(memo) The adjustment value of the brightness is common to video.