Sharp XL-DH10NH - Timer and Sleep Operation (Remote Control Only)

04/1/28 XL-DH10N 20H_001 EN
E-18
9
8
7
6
5
4
3
2
1
9
Timer and sleep operation (Remote control only)
Timer playback:
The unit turns on and plays the desired source (CD,
TUNER, USB, iPod) at a preset time.
Before setting timer:
CD
USB
MUTE
MUTE
CLOCK/TIMER
CLOCK/TIMER
TUNING/
FOLDER
AUX
AUX
PTY
PTY
RDS
RDS
■ Timer playback
1
Check that the clock is set to the correct time (refer to
page 6).
If it is not set, you cannot use the timer function.
2 For timer playback, load the disc to be played back.
1 Press the ON/STAND-BY button to turn the power on.
2 Press the CLOCK/TIMER button for about 2 seconds.
3 Within 10 seconds, press the CLOCK/TIMER button.
4 Press the or button to set hour then press the
CLOCK/TIMER button.
5 Press the or button to set minute and then
press the CLOCK/TIMER button.
6 Switch input with the or button to select “TMR-
OFF” and then press the CLOCK/TIMER button.
7 Press the or button to set hour and then press
the CLOCK/TIMER button.
8 Press the or button to set minute and then
press the CLOCK/TIMER button.
9 To select the timer playback source, switch input with
or button to select “SOURCE”, then press the
CLOCK/TIMER button.