Sharp XL-HP888V - Page 39

04/5/17 XL-HP888V(Z)E4.fm
E-38
ENGLISH
TINSZA075AWZZ
4
XL-HP888V
Tape Recording
" Recording from a CD (CDs)
You can record the desired CD using the CD DIRECT PLAY button.
To stop recording:
Press the (TAPE ) button.
The disc and tape will stop.
Sequential recording from several discs:
To perform programmed recording:
To stop recording:
Press the (TAPE ) button.
The disc and tape will stop.
Note:
To record on both sides, begin with side A. (If recording is started
from side B, the tape will not switch over to side A.)
Auto restart function:
If the recording side is switched from side A to B during recording,
the system will record the interrupted track on side B from its begin-
ning. The recording will be made without cutting the beginning of the
track on side B.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the CD/VIDEO CD (CD) button.
3
Load a cassette into the cassette compartment with side A
facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
4
Press the button to choose one side or both sides.
... To record on both sides.
... To record on only one
side.
5
Press the button.
Recording will be paused.
6
Press one of the 1 - 5 buttons to select the desired disc.
7
Within 5 seconds, press the CD DIRECT PLAY button to
start recording.
!
Recording starts from side A.
!
Recording is started from the selected disc. When the play-
back of the last track is finished or the end of the tape is
reached, the disc and the cassette will stop automatically.
!
Playback of the disc will start approximately 7 seconds after
the tape starts.
1 Perform steps 1 - 6 in "Recording from a CD (CDs)".
2 Within 5 seconds, press the / ( ) button to record on side A,
or the ( ) button for side B.
1 Programme discs and tracks. (See page 29.)
2 Press the button.
3 Press the / ( ) button to record on side A, or the ( ) button
for side B.