16
Setup & Connections
Operating the Remote Control
The remote control can be used to control the projec-
tor within the range shown on the left.
• The signal from the remote control can be reflected off a
screen for easy operation. However, the effective distance
of the signal may differ due to the screen material.
Remote Control
Remote Control
45˚
7 m
30˚
30˚
45˚
30˚
Using the remote control in a dark
room
The backlights of the operation buttons can be turned
on for five seconds and off by pressing BACKLIGHT.
If you want to turn off the backlights while they are on,
press BACKLIGHT again.
BACKLIGHT button
Using as a Wired Remote Control
When the remote control cannot be used due to the
range or positioning of the projector (rear projection,
etc.), connect a 3.5 mm stereo minijack cable
(commercially available) from the wired remote control
jack on the top of the remote control to the Wired remote
control jack on the back of the projector.
3.5 mm stereo minijack cable
(commercially available)
To Next Page
Loading...
