42
Basic Operation
Selecting the Transmission Speed (RS-232C)
This menu allows you to adjust the transmission speed
of the RS-232C connection by selecting the baud rate.
1 Press MENU.
2 Press / to select “Options”.
3 Press
/ to select “RS-232C”, and then press
.
4 Press
/ to select the desired baud rate.
5 Press ENTER to save the setting.
6 To exit the GUI, press MENU.
• Make sure that both the projector and computer are set for
the same baud rate. Refer to the computer’s operation
manual for instructions for setting the baud rate.
(GUI) On-screen Display
1,6
5
2,3,4
To Next Page
Loading...
