Sharp XV-Z9000E

37
Basic Operation
Turning On/Off the On-screen Display
This function allows you to turn on or off the on-screen
messages that appear during input select.
1 Press MENU.
2 Press / to select “Options”.
3 Press / to select “OSD Display”, and then
press .
4 Press / to select the desired On-screen
Display.
5 Press ENTER to save the setting.
6 To exit the GUI, press MENU.
(GUI) On-screen Display
Setting the Video Signal (VIDEO menu only)
The video input system mode is preset to “Auto”;
however, it can be changed to a specific system mode
if the selected system mode is not compatible with the
connected audiovisual equipment.
1 Press MENU.
2 Press / to select “Options”.
3 Press / to select “Video Systems”, and then
press .
4 Press / to select the desired video system
mode.
5 Press ENTER to save the setting.
6 To exit the GUI, press MENU.
• When the system mode is set to “Auto”, you may not receive
a clear picture due to signal differences. Should this occur,
switch to the video system of the source signal.
• AUTO cannot be set for PAL-M and PAL-N input signals.
Select “PAL-M” or “PAL-N” in “Video System” menu for PAL-
M and PAL-N input signals.
(GUI) On-screen Display
DescriptionSelected item
Normal
Level A
Level B
Description of OSD Display
All On-screen Display are displayed.
INPUT and AUTO SYNC are not displayed.
All On-screen Display are not displayed (except MENU,
KEYSTONE and warning display (Power off, Temp., Lamp
etc.)).
1,6
5
2,3,4
1,6
5
2,3,4