0
Battery cover attachment
ZQ-5000
Z&-5200
@
Temporary fixing of PET
Perform the following procedure with the set closed.
0
Insert the LCD spacer between the LCD and the PET. (Be
careful to the direction of the LCD spacer.)
X
Insert so that the cushion side come in the side of LCD
reflection plate side.
Cp
Remove the back up tape of PET (C). Slightly pull PET (C) and
attach it.
_----
Fold in front of the duplex tape.
.,’
’
-\
\
\
1
stripe
00 has
!nce
as
0
Set the slider to back up side, and insert the back up battery
lid.
Q
Place the back up battery lid as shown below, and move the
slider to the main side.
Q
Insert the main battery lid to the same position of the back up
battery lid, and move the slider to the center.
‘\
0
@
Attach the cabinet lock spring as shown below:
Key inside cabinet
/
CAbinet lock spring
LCD
spacer
Q
Slightly press screwdriver (B) and pull PET (C) and fix with
tape.
Fixing tape
@
Fold the PET (C) as shown below and fix with tape. Do not
apply the fixing tape to the heat seal section.
Fixing tape
Folding
\
-/
X
Attach the fixing tape to the center of PET.
@
Spacer attachment reference
Spacer
0
operation label attachment reference
Reference
c
To Next Page
Loading...
