How to stop hissing noise during AM reception on Sherwood Receiver?
If you're hearing continuous or intermittent hissing noise during AM reception, especially at night, with your Sherwood Receiver, it could be caused by motors, fluorescent lamps, or lightning. Try to keep the receiver away from these noise sources.
General| Channels | 5.1 |
|---|---|
| Surround output | Dolby Digital, DTS |
| Tuning range | FM: 87.5 MHz - 108.0 MHz, AM: 530 kHz - 1710 kHz |
| Total Harmonic Distortion (THD) | 0.08% |
| Input Sensitivity | 200mV (line) |
| Signal-to-Noise Ratio | 100 dB |
| Digital inputs | coaxial, optical |
| Video Connections | composite |
| Power Output | 100W per channel (8 ohms, 20Hz-20kHz, 0.08% THD) |
| Frequency Response | 10 Hz - 100 kHz |
Essential preliminary reading before powering on the unit for the first time.
Instructions for connecting FM and AM antennas to the receiver.
Guidance on connecting various video sources like DVD players and TVs.
Instructions for connecting audio devices such as CD players and tape decks.
Connecting external sources with 6, 7, or 8 channel analog audio outputs.
Connecting digital audio sources via optical or coaxial inputs/outputs.
Connecting a powered subwoofer to enhance bass reproduction.
Guidance on correctly connecting front, surround, and back speakers.
Recommendations for optimal speaker positioning in a listening environment.
Step-by-step guide to selecting and playing audio/video program sources.
Automated speaker setup and channel level calibration.
Selecting speaker sizes (Large/Small) and subwoofer presence.
Setting speaker distances for accurate delay time adjustment.
Setting the crossover frequency for 'Small' speakers.
To Next Page
