44 45
Section 7 Maintenance after the work
1. Maintenance Services after Operation
● Before covering the vehicle with a sheet,
stop the engine and wait for the engine and
muffler to cool down completely.
After operation, wash the machine in water,
wipe away the moisture completely, and apply
grease to each grease nipple.
● Before starting inspections, maintenance
services or repairs, be sure to stop the
engine. If not, you may be caught by
moving parts of the machine and injured.
● Start the inspections or maintenance
services after heated parts of the muffler
and engine have completely cooled down.
If not, you may be burnt.
[Cautions for Handling]
● Avoid water from being splashed on electric
parts as far as possible. If not, electric parts
may be damaged.
2. Opening/closing the bonnet
(1) Release the right and left bonnet catches.
(2) Raise the bonnet until the bonnet
supporting point is exceeded.
(3) To close the bonnet, push it down.
3. Cleaning the Radiator
Grass attached to the dashboard or radiator
screen may cause overheat. Before starting and
after completing operation, always check and
clean the screen and check it during operation
depending on the operation conditions.
(1) Open the bonnet.
(2) Pull out the radiator screen upward and
remove grass waste, dust, and other foreign
substances attached to it.
(3) If such foreign substances are attached to
the radiator surface, clean the radiator taking
care not to damage the fins.
(4) The net can be removed and reinstalled
without tools (by the lock catch at 2 points).
Blow off the lawn grass and other foreign
substances with air when cleaning the
vehicle.
Dange
Caution
To Next Page
Loading...
