Shimadzu ATX Series Service Manual

1
1. Operations for Adjustment
For the general operations method, see the User's Manual for the ATX Series.
1.1. Entering the Service Mode
Move from user mode to service mode as follows.
(1) In the user mode mass display state, keep pressing [POWER] and [PRINT] keys.
(2) Release the keys.
(3) Press down on the [CAL] and [MENU] keys.
(4) The password input display appears. Flashing
Use the arrow keys to input numbers.
Input 00321 as the display maintenance mode password, and press the [→O/T←] key.
(5) When the password is approved, the service mode opens.
Alternately, you can enter service mode by inputting the display maintenance mode command "@SVC=321"
from the PC.

Shimadzu ATX Series Specifications

General

Brand	Shimadzu
Model	ATX Series
Category	Scales
Language	English