29
Installation/removal
Installing the battery mount
6. Install the upper case.
(1) Open the charging port cap and pull it out fully.
(2) Insert the plug unit into the lower case. Make sure that the plug part of the plug unit
and the charging port are sufficiently exposed from the lower case.
(3) Align the two screw holes on the upper case with the lower case, then tighten the
upper case mounting screws.
(4) After installing, perform the following:
– Firmly close the charging port cap.
– Pass the power cord through the frame and leave it hanging over the drive unit
installation area.
(1)
(4)
Charging port cap
Charging
port
(2)
Plug unit
Lower case
Plug part
0.6 N·m
Upper case mounting
screw
Charging port cap
Upper case
(3)
NOTICE
• Check that the power cord is not twisted between the upper case and lower
case, or otherwise routed in a forced manner.
To Next Page
Loading...
