22
BT-E8035
•
This section describes an example of a frame design where the battery is removed/installed from the bottom.
•
When using a battery cover from another manufacturer, remove the battery cover before removing the battery.
1.
Turn the power OFF.
If there is a keyhole cap, open it.
*
The position and operation of the power switch differs depending on
the frame design.
Power switch
2.
Release the battery lock.
(1) Insert the key or hexagon wrench into the key cylinder of the battery mount.
(2) Support the battery with your hand, and turn the key or hexagon wrench.
The battery is unlocked. The double latch plate retains the battery in the designated position and prevents it from falling
out.
If the battery does not go down into the designated position, pull out the battery with your hand while turning the key
or hexagon wrench.
(1)
Key cylinder
Key
(2)
(2)
NOTICE
• If the battery is retained with a double latch plate, the double latch plate could deform if struck by a strong external force, causing the battery to drop.
To Next Page
Loading...
