32
Installation/removal
Installing the battery mount
2. Temporarily install the key unit.
Key units are not included with SHIMANO products.
Key unit mounting screw
(Temporary)
Spacer
Spacer
Front
3. Use TL-BME02 to determine the location for the key unit.
(1) Align the two protrusions on the key unit with the holes in TL-BME02.
(2) Adjust the location of the key unit so that the contact surface of TL-BME02 will be
pushed against the lower case as shown in the figure.
(3) Tighten the key unit mounting screws.
To Next Page
Loading...
