Proceed to adjust according to the symptom, as shown below.
Change the adjustment value according to the symptom, and repeat the following until the abnormal noise
or unusual feel is resolved.
If the symptom is improved, or there is no noticeable change
If the symptom is worse
Change the adjustment value another step in the same direction (positive or negative) as the change
that was just made.
(1)
Return to the basic screen, and once again shift gears to check the symptom.
Clamp band type
(SC-EN600)
cycle computer example
Switch unit integrated type
cycle computer example (SC-EN500)
(2)
Change the adjustment value two steps in the opposite direction (positive or negative) as the change
that was just made.
(1)
Return to the basic screen, and once again shift gears to check the symptom.
Clamp band type
(SC-EN600)
cycle computer example
Switch unit integrated type
cycle computer example (SC-EN500)
(2)
4.
Finally, ride the bicycle and try shifting gears to check that the abnormal noise or unusual feel has been
resolved.
5.
Maintenance
Gear shifting adjustment with the electronic gear shifting unit [Adjust]
55
To Next Page
Loading...
Need help?
General