Connection and communication
with devices
Introduction
Connecting the bicycle to a device allows you to configure the system and update firmware.
E-TUBE PROJECT is needed to configure the setting of the SHIMANO STEPS and to update firmware.
Download E-TUBE PROJECT from our support website ( https://bike.shimano.com/e-tube/project.html ).
For information on how to install E-TUBE PROJECT, check the support website.
This manual describes how to connect to E-TUBE PROJECT Professional. Components that support Bluetooth
®
can also be operated via E-TUBE PROJECT Cyclist by wirelessly connecting to a smartphone. Refer to the user's
manual.
PC connection and communication are not possible when charging the battery. Do not connect to a
device while the battery is being charged.
When a connection is established between E-TUBE PROJECT and the cycle computer or all SHIMANO
STEPS components, the SHIMANO STEPS logo or E-TUBE is displayed on the screen of the cycle
computer.
The PC linkage device is needed to connect SHIMANO STEPS to a PC. Junction [B] will be needed in the
following situations:
When there are no free E-TUBE ports on the cycle computer
When the configuration without cycle computer is applied
If the PC link cable included with the SM-PCE02 is not the EW-SD300 type, use a conversion adapter
(EW-AD305) to connect the wire to the EW-SD300. The EW-SD300 type PC link cable can be purchased
as a service part.
Firmware is subject to change without notice.
Connection and communication with devices
Introduction
45
To Next Page
Loading...
Need help?
General