SHOWTEC Compact Par 7 Tri - Device Operation; Operation Safety Instructions; Available Control Modes

17
Compact Par 7 Tri
Product code: 42580
6. Operation
Safety Instructions for Operation
Attention
This device must be used only for the purposes it is designed for.
This device is intended for professional use as a light effect. It is suitable only for indoor installation. This
device is not suitable for households and for general lighting.
Any other use, not mentioned under intended use, is regarded as non-intended and incorrect use.
Attention
Power supply
Before connecting the device to the power supply, make sure that the current, voltage and frequency
match the input voltage, current and frequency specified on the information label on the device.
Control Modes
The Compact Par 7 Tri can be operated with a DMX controller, and as a stand-alone device or in a
master/slave setup without a DMX controller.
The Compact Par 7 Tri supports the following control modes:
● Stand-alone: Auto operation mode (auto program, built-in chases, color presets), manual
color mode, sound-controlled operation mode (auto program)
● Master/Slave: Auto operation mode (auto program, built-in chases, color presets), manual
color mode, sound-controlled operation mode (auto program)
● DMX-512: 3 channels, 4 channels and 8 channels
For more information about how to connect the devices, refer to 5. Setup on pages 14–16.
To operate the device manually as a stand-alone device or in a master/slave setup:
01) Select built-in program Pr01 in the main menu.
02) Adjust the intensity values for the colors. See 6.6.1.1. Manual Color Mode on page 22 for more
information.
03) Add strobe effect. See 6.6.1.1. Manual Color Mode on page 22 for more information.
In built-in programs mode you can select one of the built-in programs (Pr02-Pr10). To run one of the built-
in programs:
01) Select one of the 9 built-in chases. See 6.6.1.2. Built-in Programs on page 23 for more information.
02) Add strobe effect or adjust the chase speed. See 6.6.1.2. Built-in Programs on page 23 for more
information.
In auto operation mode you can run the auto program. To run the auto program:
01) Select the auto program. See 6.6.2. Auto Mode on page 23 for more information.
02) Add strobe effect, add fade time or adjust the chase speed. See 6.6.2. Auto Mode on page 23 for
more information.
For more information about sound-controlled operation mode see 6.6.5. Sound Mode on page 24.