04) Cooling fan
05) Safety eye
06) 5-pin DMX signal connector OUT
07) 3-pin DMX signal connector OUT
08) Pro power connector Gray OUT
09) Ground/earth connection
10) OLED display + control buttons
11) Fuse T2AL/250V
12) 3-pin DMX signal connector IN
13) 5-pin DMX signal connector IN
14) Pro power connector Blue IN
15) Power switch ON/OFF
Installation
Remove all packing materials from the Sunstrip LED. Check if all foam and plastic padding is removed.
Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Setup and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 110 V specification product on 240 V power, or vice versa.
Connect the device to the main power supply.
To Next Page
Loading...
Need help?
General
