QUICK
START
GUIDE
1 .
3.
5.
Connect receiver to power source.
Press group button on receiver to perform a group
scan.
On the transmitter, set the group and channel to
match the receiver. The audio LED on the receiver
should illuminate.
[fl]
[I]
group
channel
[21
E
If setting up additional systems, leave the first transmitter and re-
ceiver
on
. For each additional receiver, manually set the group to
match the first receiver.
Note: The receiver will automatically perform a channel scan to
find an available frequency after the group has been selected. Set
the transmitter frequency to match the receiver.
2.
4.
6.
Connect receiver to mixer or amplifier. Hold power
button to turn on.
Install batteries and turn on transmitter.
If sound
is
too faint or distorted, adjust the gain
accordingly.
To Next Page
