Shure BLX2 User Guide

Shure Incorporated
14/25
•
•
•
•
•
•
•
•
Removing and Installing Identification Caps
The BLX2 is equipped with a black identification cap from the factory (dual vocal systems ship with additional gray
cap).
To remove: Remove battery cover. Squeeze sides and pull off cap.
To install: Align the cap and click into place. Replace battery cover.
An Identification Cap Kit containing assorted colored caps is available as an optional accessory.
Troubleshooting
Issue Indicator Status Solution
No sound or faint sound Receiver ready LED on Verify all sound system connections or adjust
gain as needed (see Adjusting Gain)
Verify that the receiver is connected to mixer/
amplifier
Receiver ready LED off Turn on transmitter
Make sure the batteries are installed
correctly
Perform transmitter setup (see Single
System Setup)
Insert fresh batteries
Receiver LED screen off Make sure DC adapter is securely plugged
into electrical outlet.
Make sure receiver is powered on.

Shure BLX2 Specifications

General

Battery Life	Up to 14 hours
Battery Type	2 AA batteries
Modulation	FM
Transmitter Type	Handheld
Compatibility	BLX Series
Frequency Response	50 Hz to 15 kHz
Operating Range	300 ft (91 m) typical
Microphone Capsule	SM58
RF Output Power	10mW
Dynamic Range	100 dB