Shure Microflex MXW6/O-Z10 User Manual

Shure Incorporated
2/100
Table of Contents
MXW Microflex® Wireless 4
Overview 4
General Description 4
Features 5
MXW Wireless System 6
Hardware Description 9
Audio Network Interface (ANI) 10
Access Point Transceiver (APT) 13
Networked Charger (NCS) 15
Microphone Transmitters 17
Rechargeable Batteries 23
Installation 27
Additional Equipment 27
Connecting MXW Components 28
Rack Installation 30
Securing the Charging Station 30
Two-Channel Charger Wall Mount 31
Mount the Access Point Transceiver 36
Power the Hardware 38
Open the MXW Control Software 40
System Set Up 40
Group Devices to Form Audio Channels 41
Channel Routing between Devices 44
Link Microphones to Group Channels 46
Preparing a Backup Microphone 47
Exchanging or Removing a Component 49
Link a Microphone Over the Network 49
Large Installations 50
Shure SystemOn Software For Managing Large Systems 5
0
High Density Mode 50
Configurations: Managing Multiple Groups 50
Wireless Management 51
Overview of Channel Coordination 51
Scanning Available RF Spectrum 52
PHS Detection 53
Identifying PHS Detection Errors 53
Setting RF Power 54
Using Multiple 2- or 4-Channel Access Points 55
Networking 57
Networking Best Practices 57
Configuring IP Settings 57
Advanced Setup 59
Software 62
MXW System Control Software 62
Control Software for the MXW Audio Network Interface 76
Dante Software by Audinate 80
Firmware Updates 81
Troubleshooting 81
Additional Resources 83
Factory Reset 83
Accessories and Model Variations 84
Microflex Wireless Specifications 87
System 88
Transmitters 88
Access Point Transceiver (APT) 91
Networked Charging Station (NCS) 92
Audio Network Interface (ANI) 93
Transmitter Output Power 95
Wiring Diagram 96

Shure Microflex MXW6/O-Z10 Specifications

General

Brand	Shure
Model	Microflex MXW6/O-Z10
Category	Microphone system
Language	English