Shure Incorporated
27/100
1.
2.
3.
4.
5.
6.
System Settings Runtime (hours)
LED Density Mode MXW1
MXW2
(SB902)
MXW2
(SB905)
MXW6 MXW8
External HD 8 15 30 8 8
External SD 7 14 26 7 7
Internal HD 7 14 29 8 7
Internal SD 6 12 23 7 6
Tip: If additional runtime is needed, make sure the RF Power is at the lowest setting for the size of the room. RF power is set
from MXW control software > Preferences tab.
Battery Replacement
LithiumIonBatteriesexperiencealinearreductionincapacity.Shurerecommendsestablishingabatteryreplacementsched
ule customized to the client requirements and replacing batteries when the capacity is no longer acceptable.
Important: After installing a new battery, reset the battery health statistics that are stored in the microphone following the steps
in Reset the Microphone Battery Statistics in the previous section.
MXW1, MXW6, MXW8 Battery Replacement
Unscrew and open the battery door on the bottom of the transmitter.
Remove battery by gently disconnecting the battery connector from the transmitter.
Connect the replacement battery's connector to the transmitter.
Replace the battery with the label facing out.
Close the door and tighten the screw.
Dispose of batteries properly. Check with your local vendor for proper disposal of used batteries.
MXW2 Battery Replacement
MXW2 batteries should be replaced by qualified service personnel only.
Installation
Additional Equipment
Network Cables
Use shielded Cat5e (or higher) Ethernet cables, limiting cable runs to 100 meters maximum
between network devices.
Audio Cables
Reference the hardware kit user guide supplied with the MXW Audio Network Interface to
assemble audio cables to the connectors.
To Next Page
Loading...
Need help?
General
