Shure Incorporated
25/50
RF
Transmitter RF Power
Reference the following table for setting RF Power:
RF Power Setting System Range Application
1 mW 33 m (100 ft.) For increased channel reuse at close distances
10 mW 100 m (330 ft.) Typical setups
20 mW >100 m (330 ft.)
For hostile RF environments or longdistance ap
plications
Note: Using the 20 mW setting decreases the transmitter battery runtime and reduces the number of compatible systems.
Interference Detection
Interference Detection monitors the RF environment for potential sources of interference which can cause audio dropouts.
When interference is identified, the RF LEDs illuminate red and the following warning displays on the receiver LCD panel.
If the warning display persists or the audio drops out repeatedly, perform a Scan and Sync at the first opportunity to find a clear
frequency.
Advanced RF
RF Mute
Use this to turn on a transmitter without interfering with the RF spectrum.
Press and hold the exit button during power-on until RF MUTED is displayed. To un-mute, restart the transmitter.
To Next Page
Loading...
