17
English
Onboard SuperIO Device
Options are in its sub-menu.
Press <Enter> to enter the sub-menu of detailed options.
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC)
installed on the system board and you want to use it.
If you install add-on FDC or the system has no floppy drive, select
Disabled in this field.
Ø The choice: Enabled or Disabled.
Onboard Serial Port1/2
Select an address and corresponding interrupt for the first and sec-
ond serial ports.
Ø The choice: 3E8/IRQ4, 2E8/IRQ3, 3F8/IRQ4, 2F8/IRQ3, Auto
or Disabled.
Onboard Parallel Port
This item allows you to determine onbaord parallet port controller
I/O address setting.
Ø The Choice: 378/IRQ7, 278/IRQ5, 3BC/IRQ7 or Disabled.
Parallel Port Mode
Select an operating mode for the onboard parallel(printer) port.
Select Normal,Compatible, or SPP unless you are certain your hard-
ware and software both support one of the other avaukable modes.
Ø The Choice: SPP, EPP, ECP or ECP + EPP.
ECP Mod Use DMA
Select a DMA channel for the parallel port for use during ECP mode.
Ø The Choice: 1 or 3.
To Next Page
Loading...
