19
English
All Modes --> Off Monitor is blanked when the system enters
any power saving mode.
Ø The choice: Always On, Suspend ->Off, Susp,stby -> Off,
or All Modes -> Off.
Video Off Method
This determines the manner in which the monitor is blanked.
V/H SYNC+Blank: This selection will cause the system to turn off
the vertical and horizontal synchronization
ports and write blanks to the video buffer.
Blank Screen:This option only writes blanks to the video buffer.
DPMS Supported: Initial display power management signaling.
Ø The choice: V/H SYNC+Blank, Blank Screen, or DPMS Supported.
Switch Function
Enables you to set the System Management Interrupt (SMI) button
function in DOS.
Ø The choice: Disabled or Break /wake.
MODEM Use IRQ
This determines the IRQ which the MODEM can use.
Ø The choice: 3, 4, 5, 7, 9, 10, 11, or NA.
Hot Key Function As
This item allows you to set the Hot Key Function.
Ø The Choice: Power off, Suspend or Disable.
HDD Off After
The IDE hard drive will spin down if it is not accessed within a specified
length of time. Options are from 1 Min to 15 Min and Disable.
Ø The choice: Disabled, 1 Min ~ 15 Min.
Power Button Override
Pressing the power button for more than 4 seconds forces the system to
enter the Soft-Off state when the system has "hung.".
Ø The choice: Instant-Off or Delay 4 Sec.
Power State Resume Control
This item enables your computer to automatically restart or return to its
last operating status after power returns from a power failure.
Ø The choice: Always Off, Always On, Keep Pre-state.
To Next Page
Loading...
