Batch Scanning (Inventory Mode)
Operating Instructions
IDM corded & IDM Bluetooth
© SICK AG · Germany · All rights reserved · Subject to change without notice
2.7.3 Transmit stored data
The scanner is preset to transmit all the stored data by scanning the “Transmit Stored Data” command.
During the transmission, the scanner will emit continuous short clicks and the link indicator will blink blue.
Then the scanner will give two short beeps after data transmission is completed.
You are still able to set the scanner to transmit the stored data by placing the scanner onto the cradle as well.
Place scanner onto the cradle
Scan command or place scanner onto the cradle
2.7.4 Delete data
If a wrong barcode was scanned, the “Delete Last Scanned Data’’ command is helpful to recover mistakes. By
scanning the ‘’Delete Last Scanned Data’’ command, the last stored data can be deleted.
The scanner is preset to keep all the stored data until you scan the “Clear All Stored Data” command.
However you are also able to change the setting to “Auto Delete Stored Data after transmission”. (Refer to
chapter 3.10.3)
To Next Page
Loading...
