SICK InspectorP - Default Chapter; Table of Contents

ABOUT THIS DOCUMENT 1
8024534 / 16UW / 2020-02-26 Operating Instructions | InspectorP Rack Fine Positioning 3
Subject to change without notice
Contents
1 About this document ............................................................................ 5
1.1 About these operating instructions .............................................................. 5
1.2 Explanation of symbols ................................................................................. 5
1.3 Further information ....................................................................................... 6
2 Safety information ................................................................................ 7
2.1 Intended use ................................................................................................. 7
2.2 Improper use ................................................................................................. 7
2.3 Internet protocol (IP) technology .................................................................. 7
2.4 Limitation of liability ...................................................................................... 8
2.5 Modifications and conversions .................................................................... 8
2.6 Requirements for skilled persons and operating personnel ...................... 8
2.7 Operational safety and specific hazards...................................................... 9
3 Product description ............................................................................. 10
3.1 Scope of delivery ......................................................................................... 10
3.2 Function and use ........................................................................................ 10
3.3 Principle of operation .................................................................................. 11
3.4 Single deep applications............................................................................. 12
3.5 Single and double deep applications ......................................................... 12
3.6 Positioning mark ......................................................................................... 12
4 Installation ............................................................................................ 14
4.1 Software installation ................................................................................... 14
4.1.1 SICK AppManager ............................................................................ 14
4.1.2 SOPASair (web server) ..................................................................... 15
4.1.3 Saving parameter set ...................................................................... 15
4.1.4 Installing firmware updates ............................................................. 16
4.2 Mounting ...................................................................................................... 16
4.2.1 Mounting requirements ................................................................... 16
4.2.2 Mounting procedure ........................................................................ 19
4.2.3 Mounting device............................................................................... 19
4.3 Electrical installation ................................................................................... 20
4.3.1 Notes on electrical installation ....................................................... 20
4.3.2 Interfaces ......................................................................................... 20
5 Commissioning and operation .......................................................... 21
5.1 Establishing a connection: Ethernet .......................................................... 21
5.2 Establishing a connection: PROFINET ........................................................ 21
5.3 Parameterizing device with SOPASair ........................................................ 22
5.3.1 SOPASair user interface .................................................................. 22
5.3.2 Setting up user interface ................................................................. 22
5.3.3 Fine adjustment of the device......................................................... 23