EasyManua.ls Logo

SICK RFU610-10600

SICK RFU610-10600
70 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2.7 Operational safety and particular hazards
Please observe the safety notes and the warnings listed here and in other chapters of
this product documentation to reduce the possibility of risks to health and avoid dan‐
gerous situations.
WARNING
Electrical voltage!
Electrical voltage can cause severe injury or death.
Work on electrical systems must only be performed by qualified electricians.
The power supply must be disconnected when attaching and detaching electrical
connections.
The product must only be connected to a voltage supply as set out in the require‐
ments in the operating instructions.
National and regional regulations must be complied with.
Safety requirements relating to work on electrical systems must be complied with.
WARNING
Risk of injury and damage caused by potential equalization currents!
Improper grounding can lead to dangerous equipotential bonding currents, which may
in turn lead to dangerous voltages on metallic surfaces, such as the housing. Electrical
voltage can cause severe injury or death.
Work on electrical systems must only be performed by qualified electricians.
Follow the notes in the operating instructions.
Install the grounding for the product and the system in accordance with national
and regional regulations.
WARNING
Health hazard as a result of high-frequency electromagnetic radiation!
The RFU61x-10600
1)
is designed for operation according to ETSI EN 302208. During
operation, the human exposure regulations covered by EN 50364 must be observed.
Limit human exposure to electromagnetic fields. Suitable safety distances must be
maintained during both short-term and long-term work in the radiation range of
the integrated antenna.
Minimum distances to be maintained between the antenna and the human body
during long-term transmission: 10 cm and maximum radiation power of the
antenna of 100 mW ERP (20 dBm) pursuant to ETSI.
The RFU61x-10601
2)
satisfies the limit values of the FCC for exposure to radiation in
an uncontrolled environment.
During operation, a safety distance of at least 20 cm must be maintained between
the antenna and the human body.
2.8 Repairs
Repair work on the device may only be performed by qualified and authorized person‐
nel from SICK AG. Interruptions or modifications to the device by the customer will inval‐
idate any warranty claims against SICK AG.
1)
For regional assignment, see type-specific online data sheet on the Internet at: www.sick.com/RFU61x
2)
For regional assignment, see type-specific online data sheet in the Internet at: www.sick.com/RFU61x
2 SAFETY INFORMATION
12
O P E R A T I N G I N S T R U C T I O N S | RFU61x 8024536//2019-08-30 | SICK
Subject to change without notice

Table of Contents

Related product manuals