5.2.4 Mounting device
The device can be mounted using the 2 mounting straps (supplied mounting kit part no.
2105772) after attachment on the device from the front or rear. The associated 2 M5
threaded mounting holes for the fastening clamps are each located on the outside of
the rear of the device, in the recess, see "Device view", page 15.
Figure 6: Back view RFU61x: device with mounted mounting straps
Alternatively, the device is fastened using the 2 M5 internal threaded mounting holes.
The threaded mounting holes are also located on the rear of the device.
Further, optional SICK brackets
The device can be mounted using additional optional SICK brackets, a combination of
SICK brackets and elements, or a customer-specific bracket.
SICK offers prefabricated brackets which are optimally suited for mounting the device
in a wide range of applications.
Also see on Internet at:
•
www.sick.com/RFU61x
NOTE
Dimensional drawings for SICK brackets and, if applicable, mounting instructions can
be found online at: www.sick.com
b
To do so, enter the 7-digit part number of the bracket in the search field.
User-supplied brackets
A user-supplied bracket should meet the following requirements:
■
Stable mounting device
– Allow the device to be aligned in the x and y axes.
– The mounting device must be able to bear the weight of the device, including
connecting cables, in a shock-proof manner, see "Technical data", page 61.
– In mounting situations with strong vibrations, it may be necessary to provide
shock mounts.
■
For mounting the device according to the dimensional drawing: 2 suitable holes for
M5 screws.
5.3
Mounting location
When selecting the mounting location, the following factors are significant:
5 MOUNTING
26
O P E R A T I N G I N S T R U C T I O N S | RFU61x 8024536//2019-08-30 | SICK
Subject to change without notice
To Next Page
Loading...