10.7.3 Putting the replacement device into operation
1. Backed-up configuration data: take the optional memory card from the device
being replaced and install it in the replacement device of the same type.
2. Mount and align the replacement device (see "Mounting", page 24). When doing
so, note the previously applied markings on the bracket or surroundings.
3. Reconnect the connecting cables to the replacement device (see "Electrical instal‐
lation", page 30).
4. Switch on the supply voltage for the replacement device.
The device starts with the default setting and searches for external memory media
with a valid parameter set. If the device detects storage media with a valid para‐
meter set, the device does the following:
°
Only memory card in the device:
the replacement device loads the parameter set on the memory card.
The replacement device loads the parameter set into its permanent memory and
operates according to the configuration data in the parameter set.
5. If the replacement device does not detect any external storage medium, the device
starts with its last permanently stored parameter set. In the case of devices that
have not been used before, this corresponds to the factory default setting.
w
Establish a connection to the replacement device using the SOPAS ET config‐
uration software.
w
Transfer the configuration data of the device to be replaced, which was previ‐
ously saved to the PC, by downloading it to the replacement device and per‐
manently storing it there.
TROUBLESHOOTING 10
8024536//2019-08-30 | SICK O P E R A T I N G I N S T R U C T I O N S | RFU61x
59
Subject to change without notice
To Next Page
Loading...