SICK S3000 Cold Store - About this Document

Chapter 1 Addendum Operating Instructions
S3000 Cold Store
4 © SICK AG • Industrial Safety Systems • Germany • All rights reserved 8012029/YY95/2016-02-05
Subject to change without notice
About this document
1 About this document
This document is an original document.
This addendum is only applicable to the S3000 Cold Store safety laser scanner with one of
the following entries on the type label in the field Operating Instructions:
 8011877
 8011877/TL59
 8011877/YY95
This document is part of SICK part number 8011877 (addendum operating instructions
“S3000 Cold Store Safety Laser Scanner” in all available languages).
This addendum only applies in conjunction with the original operating instructions
“S3000 Safety Laser Scanner” (SICK part number 8009791).
If not otherwise revised in this document, the information in the original operating
instructions applies, which relate to the S3000 Advanced safety laser scanner.
For the configuration and diagnostics of these devices you require CDS (Configuration &
Diagnostic Software) version 3.50 or higher.
2 On safety
2.1 Applications of the device
The S3000 Cold Store safety laser scanner is used to protect persons and plant. The
S3000 Cold Store is particularly suitable for use in cold environments.
It is possible to implement both stationary applications, e.g. area protection or gate
protection, and also mobile applications, e.g. AGV.
Ambient conditions, e.g. rain, snow, fog or incident sunlight, are only compensated to a
limited extent by the S3000 Cold Store. Usage outdoors in the open is not foreseen.
The safety laser scanner’s safety level corresponds to category 3 as per EN ISO 13849C1,
it can be used up to SIL2 as per IEC 61508.
2.2 General safety notes and protective measures
Safety notes
This addendum must be made available to the operator of the system, machine or the
vehicle where the S3000 Cold Store safety laser scanner is used, together with the original
operating instructions. The operator is to be instructed by qualified safety personnel and is
to read and follow the addendum; the operating instructions must also be followed.
Note
Note
Note

WARNING